Subject | Text |
Sanyo ds35500 goes into protection mode | Sanyo ds35500 goes into protection mode. There is no video when I first turn it on but there is audi |
DELL P1110 Protection Mode Solution Needed | Hi Sirs,
My DELL Monitor got into the protection mode with the orange LED flickering every time I |
|
Phillips 28PW6332/05 Software Protection | I've spent a while narrowing down the problem with this TV. One day it shut off and started continuo |
I agree with Mel. This sounds like an x ray protection circu | I agree with Mel. This sounds like an x ray protection circuit that is killing your set when it is a |
Panasonic DMR-E50 write protection | My Panasonic DMR-E50 has recently started telling me that my DVD-RAM discs are read only.
When I lo |
Sony KE-42TS1E goes into protection mode a couple of second. | I have a Sony Plasma KE-42TS1E which goes into protection mode a couple of seconds after switch on. |
| Check out what Microchip says:
Note the following details of the code protection feature on Microch |
Re: AVC | [quote:23d123f2da="jts1957"]What is AVC?
I'm presuming power strip or surge protection?[/quote:23d1 |
Re: service manual pioneer sx 950 | [quote:44c8db621d="joey salvatierra"]i need a service manual for my pioneer sx 950. its has a power |
Mystery Diodes | Well I'm new here and athough I know alot about tube equiptment I have limited knowledge of solid st |
need stepdown from 50v dc OCv to below 25vdc | I am upset, I ordered a solar panel and was sent a COMEPLETELY wrong panel from what i ordered, and |
LCD monitor switches off immediately after turn-on | Hi,
please help me with this one if you can.
I've got a no-name 17" LCD monitor that displays |
Protect LED | My Hitachi 50FX30B had been dead for quite a while, but this weekend I took some time to go over it |
Defective HDTV | Hello,
It is sad to say, but I think you'll have to take your tv to a technician...
When you pow |
Need a service manual,schematic for Magnavox CCR095AT TV/VCR | I need a service manual and/or schematic for a Magnavox CCR095AT TV/VCR
combo. Something in pdf for |
| if the 3a fuse went and you replaced it with a 3.15a fuse and that went the fault is not the fuse. t |
standby | Having similar issues. First the screen went bad, replaced the convergence ICs and all good again. T |
|
PHILIPS TELEVISIONS LED AND MODEL NUMBERS | HI ALL
THIS IS INPORTANT WHEN POSTING FAULTS FOR PHILIPS TELEVISIONS,ALWAY POST THE MODE |
| f61 is a protection code. it means theres is a fault with audio output ic, usually there is dc on on |
| [quote:10e5b6b520="plamensl"]Hi,
what browser are you using ?
Do you have some norton internet pro |
| Hi again,
By bypassing the main speaker relay everything works great. Does anyone know if this mi |
| I don't know. I would test all of the powersupplies and view the traces, then I would look for a pro |
| Without circuit schematic or familiarity, it is not easy for the average person. I know that some co |
| I don't think the filter capacitors should be affected, it is more likely that the problem is leakag |
Re: Basic questions about TV | [quote:27cda00d7c="Rouslan N."]I am repairing a TV for the first time and have no experience\knowled |
| Blowing speaker protection fuse suggests failure of the power amplifier output transistors. If a DVM |
Int. Philips | Hello,
Below find my only database entries for the fault you describe.
1/ TV set starts up and |
| THESE SETS WILL GO INTO STANDBY IF THERE IS A FRAME FAULT, START BY REPLACING THE FRAME IC WHICH MAY |
Busted Sensor - Misconnectecd. | I have a sensor circuit that was misconnected (DC was connected to output signals.. :( ), I have che |
toshiba laptop power problem | Hi,
I have a toshiba sattelite a30 but this problem could possibly be a fault on any laptop type.
|